VCTool 2.0

[J.Aspinen]

Nyt tulikin sitten vihdoin iso päivitys tähän erinomaiseen ohjelmaan, mm. myös PQ alustaiset autot nyt tuettuna.

Version 2.0.0.0-5 / 24-25.11.2024:

+ Two versions of VCTool in one installation: x86 and x64. Use the x64 version to work with D-PDU API drivers supplied with ODIS. 
    Many J2534 interfaces can be used in x64 mode through the D-PDU API driver. 
    Note! Direct operation with J2534 device drivers is unavailable in the x64 version—currently, the use of ECU Simulator and CAN Logger is limited to Lawicell CAN-Hacker devices. 
    Support for simulator and logger functionality via D-PDU API will be added as a priority in future updates. 
+ Support for KWP2000/TP20 protocol and vehicles built on PQ, PL, and MLB platforms. 
+ Firmware flashing for KWP2000/TP20 control units using SGO/SGM containers (ECUFlasher, BatchFlasher). 
+ Editing long and short coding for KWP2000/TP20 control units. 
+ Working with APK adaptation channels on KWP2000/TP20 control units. 
+ Performing basic settings on KWP2000/TP20 control units. 
+ Executing actuator tests on KWP2000/TP20 control units. 
+ Support for ZDC containers for KWP2000/TP20 control units in ZDCoder. 
+ Support for KWP2000/TP20 control units in the parameter loader. 
+ Support for KWP2000/TP20 control units in the login finder tool. 
+ Ability to specify a session for a known login in the login finder tool. 
+ Backup and restore support in the backup wizard for KWP2000/TP20 control units. 
+ Reading memory cells for KWP2000/TP20 control units. 
    * Fixed automatic memory cell reading. 
+ Documentation for the memory cell reading module. 
+ Support for working with J2534 interfaces via D-PDU API driver—higher speed and connection stability. May not be supported by some interfaces, such as Tactrix Openport. 
+ Use of backups as a data source for simulating vehicle connections (available only for Pro and Ultimate subscriptions). Can be used for debugging AppEngine scripts. 
    Located on a separate tab in the interface selection dialog. 
+ Support for working with KWP2000/TP20 control units in AppEngine. 
+ Support for working with measurements on KWP2000/TP20 control units. 
+ Support for KWP2000/TP20 protocol simulation in ECU Simulator. 
+ Support for diagnosing DSG DQ200 transmissions using KWP2000/TP20. 
+ Support for SOAP datasets containing information on more than one control unit. 
+ Dataset loading from the general loader (not tied to a specific control unit). 
+ Expanded firmware database (more than 34,000 containers). 
+ Viewing account operations from the program and downloading invoices in .pdf format. 
+ Improved task file creation for working with SFD2—export/import in JSON format. 
+ Support for analyzing KWP packets in CAN Logger (the entire trace, including the connection setup stage, is required for correct addressing!). 
+ Conversion of CAN bus tracing into a "flat" trace for easier analysis and data extraction. 
+ Conversion of "flat" traces into backup files that can be used in the simulator. 
+ Support for KWP2000/TP20 control units in HEX Service. 
* Numerous fixes and changes. 
* Bug fixes and stability improvements.